Running multiple channels in independent mode while using ZCU102 with ADRV9002.

Question

I tried the ADRV902_DDS_Example from Analog Devices Transceiver toolbox and it worked fine. I could visualize the output sine waveforms. 
 But when I change the EnabledChannels property to [1,2], I am getting the below error: 
 
 Does this mean we can only use one channel either 1 or 2 in Independent mode? Am I missing something?

travisfcollins · Accepted Answer

This is related to the boot file selection (specifically the devicetree used). ADRV9002 Device Driver Customization [Analog Devices Wiki] 
 If you have a split DMA configuration the data channels pull data separately. Hence the [1],[2] configuration. You need to have two instances of the adi.ADRV9002.Rx class to access each buffer (one with [1] and one with [2] set in the enabled channels). 
 If you want them to collect data synchronously between channels, then use the MIMO DMA configuration to allow [1,2] configurations. 
 -Travis)

Electronic Design Services - PartnerZone

Products In This Thread

Running multiple channels in independent mode while using ZCU102 with ADRV9002.

Thread Notes

Top Replies