How to solve the problem "please update Zynq platform SD card"

There are two development environments for ADRV9371. One is TES and one is the Prototyping Platform, each with independent SD cards.

If you want to use the TES, which is the Windows Only software with the RadioVerse logo, it has an SD card here: https://www.analog.com/en/license/licensing-agreement/transceiver-evaluation-software.html

The SD card you are using is for the Prototyping Platform, which uses IIO-Scope or MATLAB for remote eval or streaming: https://wiki.analog.com/resources/eval/user-guides/mykonos

You should have gotten two SD cards with the ADRV9371 kit. If not just burn one from the first link above for TES.

-Travis

There are two development environments for ADRV9371. One is TES and one is the Prototyping Platform, each with independent SD cards.

If you want to use the TES, which is the Windows Only software with the RadioVerse logo, it has an SD card here: https://www.analog.com/en/license/licensing-agreement/transceiver-evaluation-software.html

The SD card you are using is for the Prototyping Platform, which uses IIO-Scope or MATLAB for remote eval or streaming: https://wiki.analog.com/resources/eval/user-guides/mykonos

You should have gotten two SD cards with the ADRV9371 kit. If not just burn one from the first link above for TES.

-Travis

thank you so much ,i do created the SD card used for Prototyping Platform.However i have followed the link:

https://www.analog.com/en/license/licensing-agreement/transceiver-evaluation-software.html

1.download the TES

2. Create the SD card which include 

BOOT.bin

devicetree.dtb

uImage

DG1_DS_DIR_HDR

DG1_DS_VOL_HDR

When i insert the SD card into my ZC706 motherboard ,nothing appear on my UART console.And the TES is also can't connect with my AD9371.Do i missed some important step?

thank you so much ,i followed the steps you mentioned in 

https://www.analog.com/en/license/licensing-agreement/transceiver-evaluation-software.html

However after i insert the SD card which i have already write image by using Win32DiskImager  into my ZC706,nothing appear in my UART console,it seems that the linux system doesn't boot up .Do i missed some important step?

Can you ping the board? What IP address are you using?

-Travis

i can't ping my board.I use the IP address 192.168.1.10 which is refered in <<UG992>>.Do i need to do something after i write the image in SD card? Thanks for your replay  sincerely

The problem is solved ,now i can connect my board normally.I buy an other SD card installed of the TES card and then do the all steps again,Thank you very much!!!~~