Products In This Thread

AD9081 Recommended for New Designs
The AD9081 mixed signal front end (MxFE®) is a highly integrated device with four 16-bit, 12 GSPS maximum sample rate, RF digital-to-analog converter...
Datasheet
AD9081 on Analog.com

  • State Verified Answer
  • Replies 1 reply
  • Subscribers 3 subscribers
  • Views 631 views
  • Users 0 members are here
Options
Related 

        

            Post
             Go back to editing
        

    

    


    

    









		












	
	
			
	
			
		
	
	
		

		
How Can I Use DPGDownloaderLite for Mod Mux Configuration 3B in AD9081



		

			

									
					    marktr
					
							

			
				
									
											
			
			
				
    
			
			
			    	
			                    
                
				                on Sep 7, 2022 
				
			
			
		
    

				
		
    
		    		    
		    
		    		            		        
    Category: Choose a category
    
    		        		        		    		    	
			
    Hi,
    

    As I mentioned in the title, is there a way to configure DPGDownloaderLite for Mod Mux Configuration 3B in the configuration where m is equal to 2? 
    

    My goal is to test the following image with DPGDownloaderLite .
    

    

     
    

    I am using ad9081 with ADS9
    

    Any help would be appreciated.

    thanks
    
									
			        
		
    

				
				
		
    
			
						
									
									
						
						
			
			
			
			
		
    

        
        

					
    
			
    


    


	
    
		






		

			
    
			
    Top Replies
    
		
    

		
    
			
      
												
							
    • 
				
      
					
      
												    FormerMember
											
      
					
      
						
							
															FormerMember
													
												
						
                		
    
				
						
						                        
                                                
                        
                                                	 Sep 7, 2022 
						
										
						
												+1
													
									verified
							
											
    
				
    
				
					
    Hello,

    The attachment showing ACE set-up along with MOD MUX SPI write is using the AD9986 EVB.  For the AD9082 EVB........use same settings but change the Tx Data Rate to 750 MHz since this EVB uses 100…
    
				    
			
						
		
    
		
    
					
    
	
	
    















    
	
    
	
    
					



			


				
	









	
      
	

    • 
	
      



	
			
		
	



      
	
      
		
      
							FormerMember
					
      
		
      
			
													+1
							
			
				
									FormerMember
							        
			
			
			
    
            
			                            
                        
                on Sep 7, 2022 12:06 PM
            
            
					
    
	
    

		
		
    
					
    Hello,

    The attachment showing ACE set-up along with MOD MUX SPI write is using the AD9986 EVB.  For the AD9082 EVB........use same settings but change the Tx Data Rate to 750 MHz since this EVB uses 100 MHz VCXO.  Since this configuration supports complex-IF mode that could be used for an image reject upconversion architecture, you can tune the NCO to the desired IF frequency.  You should observe an output signal appearing at DAC0 and DAC1 output.

    Regards