AD936x: FAQ

  • Created
Was this helpful?
  • Article

    AD936x Built in Self Test (BIST)

    BIST Signal Generator AD9361 and AD9364 have an internal signal generator which can be used to inject a signal into either the output of the Tx data port or the input of the Rx data port. This is useful…
  • Article

    AD936x digital interface capacitive load drive in CMOS mode

    AD936x transceiver digital driver output drive levels were chosen to minimize on chip noise due to digital waveform switching. The tradeoff associated with this approach is that the drivers cannot drive…
  • Article

    AD936x documentation changes

    This document captures the documentation changes planned for User guide and Register map for AD9361, AD9363 and AD9364 Radio Verse Transceivers. Document update and release will take time and until that…
  • Article

    AD936x Local Oscillator [LO]

    Attached document gives an overview of the LO's for AD9361 and AD9364. Attachments: AD936xLOconfiguration.docx
  • Article

    AD936x maximum Rx digital path data rates

    AD936x devices have configurable Rx digital data path rates that are a subject to maximum ratings that vary based on the location of a digital block in the data path and the decimation rates available…
  • Article

    AD936x Rx ADC basic operation and output rates

    The Rx ADC used in AD936x devices is a highly oversampled sigma-delta modulator (SDM) with an output ranging from +4 to -4. A particular ADC output sample does not necessarily represent the input signal…
  • Article

    AD936x Temperature sensor

    AD9361 / AD9363 / AD9364 temperature sensor. The internal temperature sensor value can be read using the Auxiliary ADC (AuxADC) via SPI. The AuxADC needs to be configured using the ad9361_auxadc_setup…
  • Article

    AD936x_DCOFFSET_ISSUE

    ISSUE: DC offset correction algorithm fails sometimes whenever there is a signal very close to DC (less than 7.5 kHz). DESCRIPTION: AD936X uses two level of DC offset correction: RFDC offset correction…
  • Article

    Transmit Power monitor (TPM) AD936x

    Transmit Power Monitor (TPM) functionality - AD936x The on-board transmit (TX) power monitor can be used as a power detector, enabling highly accurate TX power measurements in TDD mode. Maximum input…

Before You Switch

Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.