Category: Hardware
Product Number: ADRV9029
I am using the ADRV9025 with the ADS9-V2EBZ board and I observe a mismatch between TX1 and TX2 (phase and likely timing delay), even when transmitting the same waveform on both channels.
This mismatch degrades the combined signal.
I would like to ask:
- Is there an inherent delay between TX channels?
- Can the TRIGGER IN / TRIGGER OUT on the ADS9 board be used to improve synchronization between TX1 and TX2?
- Or is FPGA-level modification required for this?
Thank you for your support.
