Question on how to receive ORX data through JESD after DPD operation in ADRV9029

Question

It is set to 3pin ORx Selection mode as shown in the figure below.

However, although I enabled it on the RXx_en pin, ORx Data is not coming in through JESD. 
 I know that no ORX data is coming out through JESD during DPD operation. 
 But I want to receive ORX data through JESD when DPD operation is finished, please advise on how to control it. 
 Thank you for your support.

Ramarao · Accepted Answer

Justin.Jung said: According to my customer's words, RX_EN must be active for ORX data to come out as JESD. 
 Does RX_EN of ADRV9029 have to be active for JESD output of ORX Data to come out? 
 No, Only during TX ON time, you would get the ORX data and RX_EN must not be active. 
 Please keep TX_ON active for all the time and check if you could observe ORX data on the JESD)

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

Question on how to receive ORX data through JESD after DPD operation in ADRV9029