Post Go back to editing

Question on how to receive ORX data through JESD after DPD operation in ADRV9029

Category: Software
Product Number: ADRV9029
Software Version: SW6.2.0.35

It is set to 3pin ORx Selection mode as shown in the figure below.

However, although I enabled it on the RXx_en pin, ORx Data is not coming in through JESD.

I know that no ORX data is coming out through JESD during DPD operation.

But I want to receive ORX data through JESD when DPD operation is finished, please advise on how to control it.

Thank you for your support.



add
[edited by: Justin.Jung at 2:23 AM (GMT -4) on 27 Jun 2022]

Top Replies

Parents Reply
  • According to my customer's words, RX_EN must be active for ORX data to come out as JESD.

    Does RX_EN of ADRV9029 have to be active for JESD output of ORX Data to come out?

    No, Only during TX ON time, you would get the ORX data and RX_EN must not be active.

    Please keep TX_ON active for all the time and check if you could observe ORX data on the JESD

Children
No Data