ADRV9029/26 EVB Power

The full scale output power of the TRX is as below:

You can use Tx. attenuation control to change the Tx power.

BTW,Where from are you referring to +/-6dBm?

Hi all

I have this configuration as shown below

I set my signal Generator 3.5Ghz and 100Bandwith 

which is received by ADRV _RX1 

and I transmitted by using TX1 as shown before

 The problem when I tried revive the signal through the ORX1 by suing TES software

 when i switch ORX on i got 

and 

I lost signal from TX1 direct

 please could you help me why this happen and how to avoid this error?

Best Regards

Rich

Is your TX output is connected back to ORX path?

Can you just feed an RF signal at the ORX input and check if the spectrum is observed in the GUI?

The TX should not disappear when ORX is ON, can you check if the RX got turned off by mistake from the sig. gen?

Hi Ramarao

Is your TX output is connected back to ORX path? Yes mate

Can you just feed an RF signal at the ORX input and check if the spectrum is observed in the GUI? I working on these

The TX should not disappear when ORX is ON, can you check if the RX got turned off by mistake from the sig. gen?(TX on because i can see the o/p in spectrum analyzer.) 

TX-ON, RX-ON  just when i switch on ORX every thing change to off.

Hi Ramarao

Is your TX output is connected back to ORX path? Yes mate

Can you just feed an RF signal at the ORX input and check if the spectrum is observed in the GUI? I working on these

The TX should not disappear when ORX is ON, can you check if the RX got turned off by mistake from the sig. gen?(TX on because i can see the o/p in spectrum analyzer.) 

TX-ON, RX-ON  just when i switch on ORX every thing change to off.