ADRV9008-1: Calibration Required for Each Scan Above 100 MHz IBW?

Prasanth89 on Jun 8, 2026

Category: Software

Product Number: ADRV9008-1

Software Version: 2021.2

Dear Team,

We are using the ADRV9008-1 Evaluation Board and would like to use a 200 MHz IBW bandwidth for scanning.

Could you please confirm whether a calibration is required for every scan? If calibration is required, what is the maximum time it would take to complete the calibration process?

Thank you for your support.

Regards,

P Prasanth

Parents

vanitha

on Jun 29, 2026 4:50 AM
0
Yes, we would need to re-run the needed calibrations again.

As the frequency step change is more than 100 MHz, please follow below procedure.

Move the device to the radio off state.

Program the new LO frequency

Rerun the initialization calibrations by calling TALISE_runInitCals and TALISE_waitInitCals

Move the device back to the radio on state

Follow the " RF PLL FREQUENCY CHANGE PROCEDURE" from UG page 109.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Reply

vanitha

on Jun 29, 2026 4:50 AM
0
Yes, we would need to re-run the needed calibrations again.

As the frequency step change is more than 100 MHz, please follow below procedure.

Move the device to the radio off state.

Program the new LO frequency

Rerun the initialization calibrations by calling TALISE_runInitCals and TALISE_waitInitCals

Move the device back to the radio on state

Follow the " RF PLL FREQUENCY CHANGE PROCEDURE" from UG page 109.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Children

No Data

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Upcoming Learning & Events

Challenge Yourself!

What's Brewing

Places

Resources

Visit ContentZone

The Latest Read

New Release

Recent Technical Insights

Products Mentioned

Associated Drivers

Thread Details

ADRV9008-1: Calibration Required for Each Scan Above 100 MHz IBW?