Products Mentioned

ADRV9008-1 Recommended for New Designs
The receive path consists of two independent, wide bandwidth (BW), direct conversion receivers with state-of-the-art dynamic range. The complete receive...
Datasheet
ADRV9008-1 on Analog.com

Can I use 2 Receiver Channels simultaneously in ADRV9008-1

Prasanth89

on Mar 13, 2024

Category: Hardware

I am Testing the ADRV9008-1 with ZC706 Board.I have one doubt regarding usage of receiver channels, i.e can i use 2 receiver channels simultaneously in ADRV9008-1 Board. if it is possible how to do it , please give me a proper procedure.

Regards

P Prasanth

Thread Notes

Tags: adrv9008-1 hardware Wideband Transceiver IC rf and microwave RF Integrated Transceivers

0 RR4

on Mar 14, 2024 1:48 AM
are you planning to use the two receivers simultaneously with the same LO or different LO frequencies? Please refer to the user guide for more details.

https://www.analog.com/en/products/adrv9008-1.html
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 Prasanth89
on Mar 14, 2024 1:55 AM in reply to RR4
Hi RR4

I am Using Same LO Frequency. in adrv9008-1 RX bandwidth is 200MHz so can i use 100 MHz for RX1 and 100MHz for RX2 it is possible. if it is possible then how to do it, is Required any modification in Linux Drivers?
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 RR4

on Mar 18, 2024 1:48 AM in reply to Prasanth89
yes, it is possible to use the 100 MHz bandwidth of receivers, and refer to the below link for the configuration.

https://wiki.analog.com/resources/tools-software/linux-drivers/iio-transceiver/adrv9009
Cancel
Up 0 Down

Reply

Verify Answer

Cancel