Is there a way to measure TX/RX and RX/TX switching time on ADRV9002 under TDD mode?

Question

How can we measure the TX/RX and RX/TX switching time of ADRV9002 under TDD mode? Is there access on the Navassa eval board?

ADIApproved · Accepted Answer

In automated TDD assigning GPIO to Rx1 or Tx1 pins means that those eval board GPIO pins will reflect the Rx/Tx enable signals, as shown in the timing diagram in TES (once you enable automated TDD checkbox). 
 If you want to enable Tx/Rx through GPIOs then you would need to choose "Pin" as channel enablement mode in TES->Radio->Radio Control. Please also see TDD Enablement Delays tab in TES to find more accurate details on switching time.)

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

Is there a way to measure TX/RX and RX/TX switching time on ADRV9002 under TDD mode?

Thread Notes