Does anyone know of a way to adjust the frequency of the ADF4360-3 independent of the adjusting the reference, or the counter registers. Perhaps some topology that allows a small adjustment Vtune. The requirement is +/-2kHz or so.
groupUrl: https://ez.analog.com/rf/
- Home
- Blogs ⌵
- Browse ⌵
-
Support ⌵
- 3D ToF Depth Sensing
- A2B
- Aerospace and Defense (ADEF)
- Amplifiers
- Analog Microcontrollers
- Analysis Control Evaluation (ACE) Software
- Audio
- Clock and Timing
- Condition-Based Monitoring
- Data Converters
- Design Tools and Calculators
- Direct Digital Synthesis (DDS)
- Embedded Vision Sensing
- Energy Monitoring and Metering
- FPGA Reference Designs
- Industrial Ethernet
- Interface and Isolation
- Low Power RF Transceivers
- MEMS Inertial Sensors
- Motor Control Hardware Platforms
- Optical Sensing
- Power Management
- Precision Technology Signal Chains
- Processors and DSP
- Reference Designs
- RF and Microwave
- Signal Chain Power (SCP)
- Switches/Multiplexers
- Temperature Sensors
- Video
- Wide Band RF Transceivers
- Wireless Sensor Networks Reference Library
- About EZ
- More
- Cancel
