ADL5611 Inrush current ?

I'm using ADL5611 powered by dropping resistor, the power is 8 Vdc and dropping resistor is 32 Ohm,  to obtain 5Vdc at pin 3 of  ADL5611 at 94mA of absorption. The ADL5611 device does not start well. To pin 3 (RF out) the voltage is 3.1 Vdc and the device absorbing 153mA, and remains in this state. The voltage of 8Vdc is generated by a linear voltage regulator that limits output start-up current at 1 A. The ADL5611 how much current is required to turn on properly?

Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 2:31 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 2:31 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data