Step model for HMC1086F10

Hi Craig,

The Gerber files, including complete stack-up info, are located here:

http://www.analog.com/media/en/technical-documentation/evaluation-documentation/gerber-files/hmc1086f10-hmc1087f10-gerber.zip

Do those suit your requirements, or are you looking for the details of the heat-sink that's part of our board?

(Or something else?)

Regards,

SMcBride

SMcBride,

Do you specifically have a .step file of the device?

Craig

Craig F. Swanson

Research Engineer II

Information and Communications Laboratory

Communications, Systems, and Spectrum Division

Georgia Tech Research Institute

Room 560

250 14th St NW

Atlanta, GA 30318

Cell: 770.298.9156

http://www.gtri.gatech.edu<https://mail.gtri.gatech.edu/owa/redir.aspx?C=c20925f2f0af4dd29329ddf0701ecfff&URL=http%3a%2f%2fwww.gtri.gatech.edu%2f>

Hi Craig,

We do not have step file but we have .bxl file.

I am sending you these two links so you can see how to use it and check if it is useful for you at all.

http://www.analog.com/en/design-center/packaging-quality-symbols-footprints/symbols-and-footprints/HMC1086F10.html

http://www.analog.com/media/en/symbols-footprints/symbols/HMC1086F10.bxl

Can you explain in more details what you need this for in order for me to better understand?

Regards

Ivan S

Ivan,

We are creating a heatsink and need to create a model for the board for our mechanical engineers.  What is a .bxl file used for in what software tool?

Regards,

Craig

Hi Craig,

First link that I sent you contains explanation about this file and software needed.

Software name is Ultra Librarian Reader and can be downloaded in that link.

Regards

Ivan Soc