Glitch level of HMC1119

Hi Akira-San, this transition is bigger than on the data I provided earlier. I'm not sure why that is happening. I would say that the dip in power is closer to 10 dB. However, I don't see it as a problem since you are getting a drop in power during the transition. The customer should probably check as many transitions as possible if they are very concerned about increasing power during transition.

Best Regards

Eamon

Hi Akira-San,

yes the “glitch” plots on in the other EZ post ((31) As for Safe-State Transiton of HMC1119 - Q&A - RF and Microwave - EngineerZone), are from HMC1119 and show the transition between 14.5 dB and 15 dB. These are all of the results that I have. It might be good for the customer to repeat this transition on their setup to see if they get the same result.

Best Regards

Eamon