Regarding the output circuit of ADF4382

Question

On page 15, Figure 29 of the datasheet, there is a "Differential Output Power vs. Output Frequency at Various Temperatures and Voltages" section. Please tell me the parts/circuits used for measurement with Differential Output. 
 Also, do you have any data regarding output levels at 85℃?

kieranb · Accepted Answer

Hi, 
 The attached components are as per the EV-ADF4382SD1Z schematic available on the eval board webpage . Trace and connector losses have been de-embedded in the output power graph. 
 There is not any data gathered for 85℃ at the moment. However the typical expected output power would be between the 25 ℃ and 105℃ plots. 
 Regards, 
 Kieran)

kieranb · Answer

Yes it was measured differentially. The balun used was a Marki Microwave Bal0050. 
 Yes that's right subtracting 3dB would give the single ended value.

Partner Forums

Partner Libraries

Products Mentioned

Regarding the output circuit of ADF4382