ADAR1000-EVALZ_Control through GUI

Question

Dear team, 
 
 Our customer is testing the ADAR1000-EVALZ. 
 Our customer is verifying the performance using ADAR1000-EVALZ and SDP-S. 
 However, gain and phase are not controlled through GUI. 
 It is controlled only through the "Manual Register Write" menu . 
 We are waiting for your advice on how to solve this problem. 
 
 Thank you. 
 Best & Regards, 
 Josh

jdobler · Accepted Answer

Would you mind outlining the exact problem in a little more detail? The control software allows gain and phase control through either the GUI (i.e. the various check boxes and pull down boxes in the RX registers and TX registers tabs), or the Manual Register Write. 
 Remember to write 0x3860 to source gain, phase and bias data from the registers instead of the RAM.

Electronic Design Services - PartnerZone

Products In This Thread

ADAR1000-EVALZ_Control through GUI

Top Replies