LTC5589 I/Q modulator with AD9767 TxDAC reference circuit design

Question

Hi, 
 We are planning to use your LTC5589 I/Q modulator with AD9767 TxDAC for direct conversion of our modulated baseband signal upto 15MHz. 
 We are planning to operate the DAC Sampling speed around 80 to 125MSPS and base-band symbol rate from 1MHz to 15MHz and DAC is interfaced with FPGA. 
 We are looking for reference design from DAC to I/Q modulator interface section with Low pass filter for our above applications for optimum performance. 
 Please share the reference design circuits.

ADIApproved · Accepted Answer

Hello sugu89 , 
 
 My apologies for the delay in response. In the shared article, you can disregard the Single-Ended to Diff Driver circuit & refer to the DAC reconstructed LPF and LTC5589 IQ modulator interface. I believe the DAC-TO-MODULATOR INTERFACING section in page 49 of the datasheet can also be helpful. 
 Unfortunately we do not have a reference circuit specific your LPF specifications but I'm sharing here references that are available: https://tools.analog.com/en/filterwizard/ https://www.analog.com/en/app-notes/an-649.html https://www.analog.com/en/education/education-library/videos/4605094529001.html 
 As the article mentioned, Ltspice is a great tool to validate your filter design. You can represent the DAC output as a voltage source with a series resistance (or the Thevenin equivalent) equal to the DAC load resistor. Hope this helps. 
 In addition, the userguide which includes the Eval board schematic that can be used as an additional reference. there is also an ongoing Datasheet revision for the AD9117 and I'd like to share with you in advance the section that will be added under applications information: 
 "POWER SUPPLY 
 Requirements 
 
 The analog and digital sections of the AD9114/AD9115/AD9116/AD9117 have separate power supply inputs (AVDD, DVDDIO and CVDD) which can operate over 1.8 V to 3.3 V range. 
 To ensure proper operation of the device, the RESET/PINMD pin should be pulsed high after applying power to all supplies. If the device will be operated in SPI mode, the minimum duration before setting the pin low is 50ns. If the device will be operated in pin mode, there is no need to set RESET/PINMD low after pulsing it high and, alternatively, the pin can be pulled up to DVDDIO. 
 Recommendations 
 The user can employ several different decoupling capacitors to cover both high and low frequencies. These capacitors should be located close to the point of entry at the PCB level and close to the devices, with minimal trace lengths. Recommended decoupling capacitor values for each supply pin are one of each of the following: 10nF, 0.1uF, and 10uF. The smallest value capacitor should be placed nearest to the supply pin." 
 For additional clarifications regarding AD9117, Please create a new post in High speed DACs EZ. 
 Many Thanks, Lorenz)

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Latest Webinars

Challenge Yourself!

What's Brewing

Places

Resources

Highlighted Blogs

Latest Blogs

ADI Blogs

Visit ContentZone

Featured Content

View Content By Industry

View Content By Technology

Products Mentioned

Thread Details

LTC5589 I/Q modulator with AD9767 TxDAC reference circuit design

Thread Summary