Post Go back to editing

ADRF5044 RF port input impedance 50ohm measurement

Hi ADI expert, 

The ADRF5044 true table showed just only one port turn-on at one time, thus I would like to measure isolation port with 50ohm impedance to make sure assembly soldering is reliable, Do you think that workable?

Since to instrument SMU is I have to verify switch on/off routing function, so I plan to settling up very low output DC 0.5V/10mA limited to avoided by hot-switch 22dBm condition.

Do you think that workable?

Thanks.

Best Regards.

RayW.

Parents Reply Children
No Data