Questions about R7 and R10 of ADL5801


I have a question about ADL5801.

Figure 110 on page 38 of the ADL5801 data sheet shows R7 and R10.

On page 29 of the data sheet, when ENBL = L and fixed bias, the value of R10 is determined according to Table 5, and R7 and R9 are instructed to be open.


Then, when ENBL = L and R7 are set and the DETO pin and VSET pin are connected, it is recognized that R10 needs to be open. Is this correct?

I would appreciate it if you could reply.

Best regards