LTC5594 - DC2465A and DC590B show the Cannot load module for device with right connection

Firstly, I configure the DC5990B and LTC5594 with the above instructions and quickEval shows the following results

When i click the Open button, it shows

And I will shows the two photos of the conncected board

And how can I resolve this problem?

Could you try downloading and installing the module directly while we look into this issue?

http://ltspice.analog.com/quikeval/ins5594.msi

Is this OK ? The QVal still don't work

Please verify the supply voltage and current are correct. Adjust Vsupply until Vsense is 5V. The supply current should be about 470mA. Vcm should be 0.9V or floating. (Be aware that the 4 IF outputs have 0.9V common-mode voltage on them.) The jumper for Vlogic should be set to "INT" position. Make sure the DC590B's VCCIO jumper is set to 3.3V.

The supply current should be about 500mA and the current on Vcm is about 7mA. Is it OK? The other connections are corret.

500mA supply current is at the upper limit. There should be no current on Vcm. 

I also met this problem yesterday 

my demo supply voltage is 4.75 and supply current is 510 ,So is it normal ?