HMC769 Evaluation Software

Hi Gilbert,

You can follow the following steps.

-Open the software

-Click Open Interface

- Select NO for Abort Application

-Select YES for Use software without evaluation board or USB connection

-Select HMC769 from the drop down list of PLL with Integrated Microwave VCOs and click Done

- Click NO a few times when asked Abort Application

-Clik Load Reg File Tab and Search for one of the HMC769 Default Register Settings within setup directory

-Customize your register settings with the main page and detailed GUI page.

-Clik Save Reg File tab to save your register configuration

Regards,

Kudret

It doesn't solve the problem

It doesn't solve the problem

Hi,

Sorry to hear that. At which stage did you have problem?

• Couldn't run the software and quit

Hi,

When I run the software without hardware, below page opens. The steps I've mentioned above start with it. I attached the software that I use which is downloaded from the webpage. Can you try to uninstall current software and install the attached one. Which operating system are you using? It is Win10 in my case.

PLL-VCO-Evaluation-Software.zip

The download has been installed, but the problem remains.The operating system is WIN7.The screen you just displayed cannot appear.

Are you still here?Are you sure you're using the software you gave me just now?Thank you for your attention.

I will check the software in Win7 setup and will reply back to you.

• What operating system are you using? I'd like to try it. thank you

• The software runs on WIN10, as you said at the beginning.

Sadly, I switched to another computer, also WIN10, and the problem remained.The problem is not the operating system version.