I might be mistaking but in the Datasheet of the ADL5243 (https://www.analog.com/media/en/technical-documentation/data-sheets/ADL5243.pdf) on page 26 ff. the values of the Resistor R12 are given in nH instead of Ohm. I was wondering what the correct values are. I assume it is indeed a Resistor as an Inductor would not make a lot a sense right there.
I would like to operate the Amp at 1 GHz therefore the "Matching Circuit at 943 MHz" is the one I am the most interested in.
Thanks in advance
R12 is indeed a place-holder that varies depending on frequency desired. At 943 Mhz it should be a 3.3 nH inductor for best matching. At higher frequencies it becomes a zero ohm jumper, and finally…