I am testing the mm-wave a transmitter (EV2HMC7585LG) and a receiver (EV2HMC8327LG). They are directly connected with a 30dB attenuator.
However, I can see nothing from the IF outputs, even applying FFT for the received signals. Are my connections correct?
Also, there are many jumper connections on the boards. One is disconnected by default. I do not know exactly what are those jumpers used for. Is there any user guide I can refer?
hello! please share the datasheet/schematics of these boards. I have only schematics of previous revision (EV1).
We are from Northeastern University, and we bought 3 pairs of those modules but they came with no user guide. There are only the datasheets for the chips, which can be found in Analog Website:
By the way, we just want to verify the modules are working by doing a back-to-back test. It will be great that you can provide us with some guidance to test those modules!
Could you share me with the schematics of the previous revision? That would help me a lot!
I think if you have zero signal at IF inputs of upconverter you will have almost no signal at RF output. You still can expect some small output due to LO-leakage in mixers.
Here is 28 page datasheet for HMC8327:
It shows previous version of eval board. It did not have any LDOs and biasing sources and requires tangled biasing procedure at start-up. Your EV2 should have them on board.
Thanks for the information!
Another question: the datasheet is measured at IF = 1GHz. Can I input a much lower frequency like 1MHz or 1KHz? This will make my data acquisition much easier!