Hi,I am looking for a replacement power supply for the Hittite HMC T2100. The on the back of the unit next to the DIN plug it mentions 12VDC 4A. Where can I get a replacement power supply ? I could probably find another source if someone give me the pinout of the power connector or which pins are 12V and which are and. Thanks a lot everyone for your help.
We managed to find a T2100. Here is the pinout
We no longer make and sell these instruments. We can send you a sketch of the pinout if that would be helpful.
If you have access to the pinout for the connector that would be great. I can probably find a suitable 12v supply. Thanks for your help
There is actually a pinout drawing on the existing power supply (we didn't realize this until we went looking). See attached pic. You may be able to buy a replacement power supply directly from mepospower.com.
Thanks a lot. I checked with them and they don't make it anymore. Would it be too much asking if you could measure the voltage on the pins of the power adapter? The picture you sent with the adapter shows a 4 pin connector while the connector on the back of the unit is a 5 pin connector . Thanks again for your time
We have looked at a few generators around the labs here and all of the ones we found have four pins. We only have T2240 models and cannot find any T2100 models. Still,on your existing power supply module, there should be an indicator of the pinout. Do you still have the old (broken) power supply module?