The source codes for the ADF4350 and ADF4351 evaluation board control software and the evaluation board USB microcontroller firmware are attached below.
Warning: You use this at your own risk and it is not officially supported by Analog Devices.
Post any questions below.
Compiled, release download here: https://ez.analog.com/message/38857
Thanks for the source code, this allowed me to make an extension for a cheap board containing 2 ADF4351, I also wrote an alternate firmware for this board to be able to communicate.
May I post…
Just a quick note to say 'thanks' for posting the C# source. It's appreciated. I need to write a console app to talk to the ADF4351 demo board, and I thought I was going to have to spend the…
The file was found and replaced. However, it appears the linux driver doesn't initialize the firmware.
Assuming you all work for the same corporation, perhaps the two communities (linux and windows…
The software only supports the devices shown in the images in the software: EVAL-ADF4xxx-USB adapter board, SDP-B and SDP-S boards.
You will have to write custom software to support any other devices.
Where should I change and what in order to support the BF548 evaluation board?
I'm not familiar with the BF548 evaluation board. You will need to talk to someone of the Blackfin Processors forum (see above).
Just a quick note to say 'thanks' for posting the C# source. It's appreciated. I need to write a console app to talk to the ADF4351 demo board, and I thought I was going to have to spend the whole weekend staring at a lot of undocumented USB packets.
I have already posted there but still waiting for a solution that will save me development time in developing an app to control my BF547 based board.
Is the ADF435x_Source_Code_v4_2 communicate via USB bulk driver?
Is it capable to download data from the ADF435x memory.
Where is it connected in the code to the USB device?