The source codes for the ADF4350 and ADF4351 evaluation board control software and the evaluation board USB microcontroller firmware are attached below.
Warning: You use this at your own risk and it is not officially supported by Analog Devices.
Post any questions below.
Compiled, release download here: https://ez.analog.com/message/38857
Thanks for the source code, this allowed me to make an extension for a cheap board containing 2 ADF4351, I also wrote an alternate firmware for this board to be able to communicate.
May I post…
Just a quick note to say 'thanks' for posting the C# source. It's appreciated. I need to write a console app to talk to the ADF4351 demo board, and I thought I was going to have to spend the…
The file was found and replaced. However, it appears the linux driver doesn't initialize the firmware.
Assuming you all work for the same corporation, perhaps the two communities (linux and windows…
Where can I find source code for evaluation SW GUI for testing and downloading data from the BF548 eval bulk usb demo?
You should post your question on the Blackfin Processors forum: http://ez.analog.com/community/dsp/blackfin-processors
When you figure out the eval bulk USB demo, you can use the above source code to generate the register values.
Thanks. I have posted it as you suggested.
in the adf4350 sw I get the message : No USB adapter board attached. Try unplugging and re-plugging the USB cable. when I try to conect to the BF548 target.
In the device manager I can see the Blackfin BF548 USB device connected.
any advise why?
On the Select Device... tab of the software, choose SDP board (black) and then click Connect.
I have tried that as well and got SDP connection failed.
Any idea why?