uncalibrate the output power of cn0511

Question

I am currently working on a project using the CN0511 device. I am reaching out to seek assistance regarding a specific matter. 
 I have noted that the device is currently calibrated with an output power ranging from 0 to -40. 
 My questions are 
 
 How can I uncalibrate output power of the CN0511 device ? 
 how can I find calibration coefficients that stored in the onboard EEPROM? 
 
 i couldn't find it at adi cn0511_Example.py

rolmedo · Accepted Answer

May I know what setup you are using? Is it through pyadi-iio or iio oscilloscope? 
 If you're using pyadi-iio, you can check this repository GitHub - analogdevicesinc/libad9166-iio , specifically the "ad9166.c" file. Since the code was calibrated, you can set to zero or any value based on your application. 
 However, if you're using IIO oscilloscope, set to debug mode and select ad9166 as your device, set the following IIO device attributes (refer to the image below) to see the raw value and change it based on your application. 
 
 Regards, 
 -Rey)

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

uncalibrate the output power of cn0511

Thread Notes