Category: Hardware
Product Number: EVAL-ADICUP3029 and EVAL-AD5941BATZ
When using this EVAL-ADICUP3029 and EVAL-AD5941BATZ development board to get the readings of impedance of a cell, I’m not getting any results. As I’m following exactly the same steps given in this link CN0510 User Guide [Analog Devices Wiki] but I’m not getting results as per my expectation. While following the manual I’m getting some unwanted curves in sensor pal software and the code that is given is not working as per expectations after flashing it to the board to show the readings of impedance of cell through UART. Hope I could get some help in this regard.
tagged
[edited by: GenevaCooper at 2:11 PM (GMT -5) on 7 Nov 2023]
