Q
I use in a project the ADM1062 for monitoring some voltages. I want to use the
ADM1062 only for analog digital conversion from the inputs VX1-5, VP1-4, VH an
internal temperature sensor without averaging.
I don't want to use the EEPROM for configuration. I want to initialize the
ADM1062 every start up over the SMBus. Can you tell me which register I have to
write for the configuration to read the ADC Value Register
continuously?
A
Yes, this is possible. There are several ADC registers to configure and then do
the readback, they’re documented in the AN-698, and there’s also another apps
note, AN-897, dealing with how to setup and configure and use the ADC as well.