ADM1060 Power Sequencer support for USB interface

Question

Accepted Answer

Question Is there a USB programming tool for ADM1060 because parallel ports are no 
 longer available on PCs. USB-to-Parallel adapters don't work as ADM1060 
 evaluation SW can't redirect data for the ADM1060 to a virtual parallel port. 
 Is there no patches for the ADM1060 evaluation SW that could allow it to work 
 with USB?
 I saw that ADM1062 is supported for USB cable. Are there any plans to support 
 the ADM1060 also? Answer The ADM1060 does not support the USB interface and there is no plan to support 
 it. USB-SMBUS-CABLEZ is designed for use only with the newer parts: 
 ADM1062/ADM1063/ADM1064/ADM1065/ADM1066/ADM1067/ADM1068/ADM1069
 
 The ADM1060 Evaluation Software supports Windows XP only, it does not support 
 any later versions of Windows such as Windows Vista or Windows 7. It supports 
 the parallel port to I2C dongle, CABLE-SMBUS-3PINZ, but does not support the 
 USB-SMBUS-CABLEZ or USB-SDP-CABLEZ interfaces. 
 If you are looking for a programming solution for the ADM1060 for production 
 purposes, then we would strongly recommend that you look at third party 
 programming solutions from Data I/O and BP Microsystems who have good support 
 for these parts in a more production type environment.
 
 http://www.bpmmicro.com/programmers/
 
 http://dataio.com/en-us/solutions.aspx

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Upcoming Learning & Events

Challenge Yourself!

What's Brewing

Places

Resources

Visit ContentZone

The Latest Read

New Release

Recent Technical Insights

Products Mentioned

ADM1060: FAQ