I received 100W (ADP1046A-100-EVALZ) EVM board from the local distributor and started powering the board. I have change the output current parameters to 5A instead of 8A and corresponding light loads values are also changed.
Please guide us how to save the board settings after the changes.
I have received the gerber file for ADP1046A from the local analog team and fabricated 5 PCBA for our development and to integrated with our power board. How to program the new ADP1046A IC for default settings and need to change accordingly for my design (LLC topology). Meanwhile i referred AN-1383 app note and at pg.4 it describes as per below
How to read the register settings file ".46r".
Please guide us.
Please download the GUI from www.analog.com/adp1046a website.
In the GUI on the top right hand corner you'll find 2 buttons - save register settings to EEPROM and save board settings to EEPROM. I have shown a cut out below (see attachment fig1).
I highly suggest that you go to the website see all the videos under the video section (see attachment fig2).
Can i get the software code for 12V / 50A (600W) LLC topology. So that i can load the program on my new daughter which has been fabricated same as ADP1046A board.
I can modify the settings of LLC topology as per our design requirements.
1. Load the register settings ".46r" and Save.
2. Load the board settings ".46b" and save.
After the above steps, i can modify the settings as per our requirements. the process is correct?