Post Go back to editing

LTC4357 Gate pulldown VCE

Category: Datasheet/Specs
Product Number: LTC4357

Hello,

LTC4357 gate pulldown circuit is depicted as a BJT.

I'm expecting some residual VCE (~0.2V) to remain on the gate to source voltage due to the BJT discharge.

What is the maximum VCE of this pulldown? We can take the 0A case when it's discharged as much as possible.

Considering the worst case minimum threshold voltage of the FET, I do not want the FET partially turned on by residual voltage.

Thank you,

Orlando

Parents
  • Hi,

     

    I just heard back from the chip designer. Here is their response:

     

    Upon detecting a fault, the fast pull-down circuit will activate. The fast pull down provides a low impedance path from GATE to IN to quickly discharge the GATE, turning the external MOSFET off. Once the FET is off, the GATE will be at high impedance. There will be no more current flowing at the internal BJT so Vce will be 0V.

     

    Thanks!

Reply
  • Hi,

     

    I just heard back from the chip designer. Here is their response:

     

    Upon detecting a fault, the fast pull-down circuit will activate. The fast pull down provides a low impedance path from GATE to IN to quickly discharge the GATE, turning the external MOSFET off. Once the FET is off, the GATE will be at high impedance. There will be no more current flowing at the internal BJT so Vce will be 0V.

     

    Thanks!

Children
No Data

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.