I’m designing a circuit using the LT3743.
The datasheet does not provide the minimum and maximum threshold values for the PWM and CTRL_SEL pins.
Could you please provide this information?
| SLA Status | Assignee | Support Status |
|---|---|---|
| SLA Closed. Missed after 396 hours |
Mikee_Lacson_00 Peter Pham |
Awaiting Company Response |
LT3743
Production
The LT3743 is a fixed frequency synchronous step-down DC/DC controller designed to drive high current LEDs. The average current mode controller will maintain...
Datasheet
LT3743 on Analog.com
I’m designing a circuit using the LT3743.
The datasheet does not provide the minimum and maximum threshold values for the PWM and CTRL_SEL pins.
Could you please provide this information?
Hello,
Unfortunately, there is no direct measurement for PWM and CTRL_SEL min/max threshold during the product run.
Therefore, we are sorry but your requested min/max threshold values are not available.
Hello,
Thank you for your answer. I understand that there is no specific threshold.
I would like to ask the question in a slightly different way.
We have designed VOH to be 2.9 V or higher and VOL to be 0.4 V or lower.
Are these conditions sufficient to drive the CTRL_SEL pin and the PWM pin?
Hello,
Thank you again for asking.
We expect threshold range stays within 0.75V-1.5V so that would meet your condition, but we cannot confirm it, as the max/min threshold test was disabled during the production run.
Regards,
Hello,
Thank you for your reply. Your explanation was very helpful, and I will take it into consideration.