Category: Datasheet/Specs
Product Number: ltc4451
With VCC=GND
1st: SHDN#=3V
2nd: IN=15V
Is it okay to turn on the power in this order?
With VCC=GND
1st: SHDN#=3V
2nd: IN=15V
Is it okay to turn on the power in this order?
I did this test to the evaluation board.
Test conditions: RLOAD=1kΩ, SHDN#=3V, VIN rises from 0V to 15V, then toggle SHDN# to check if NFET turns off and on (VFWD should switch from 15mV to 700mV)
Behavior is as expected. Part survived.
-Aaron
I did this test to the evaluation board.
Test conditions: RLOAD=1kΩ, SHDN#=3V, VIN rises from 0V to 15V, then toggle SHDN# to check if NFET turns off and on (VFWD should switch from 15mV to 700mV)
Behavior is as expected. Part survived.
-Aaron
