Hello ADI support,
I am simulating on ADP2371-ADJ 's LTspice model.
It can work at FSEL=High=Vin(fsw=1.2MHz), however it can not work at FSEL=Low=GND(fsw=600kHz).
Is it rooted by LTspice's internal model issue ?
Regards,
Yuta Ueno / Marubun FAE
ADP2371
Recommended for New Designs
The ADP2370/ADP2371 are high efficiency, low quiescent current, 800 mA buck (step-down) dc-to-dc converters in small 8-lead, 3 mm × 3 mm LFCSP (QFN) packages...
Datasheet
ADP2371 on Analog.com
Hello ADI support,
I am simulating on ADP2371-ADJ 's LTspice model.
It can work at FSEL=High=Vin(fsw=1.2MHz), however it can not work at FSEL=Low=GND(fsw=600kHz).
Is it rooted by LTspice's internal model issue ?
Regards,
Yuta Ueno / Marubun FAE
Hi mrbyu ,
Can you share your simulation file so I can further investigate if this is a model issue.
Best Regards,
Earl
Hello EarlJohn-san,
Thank you for your support. I share the simulation result.
This circuit is changed only connection of FSEL pin from LTspice's preset(Example circuit).
When FSEL=Low=GND(fsw=600kHz), LX is not switchng and Vout is not rising to target voltage(5V).
Green line is Vout, Blue line is LX(V) in the capture.
Regards,
Yuta Ueno / Marubun FAE

