Category: Hardware
Product Number: LTC4013
Software Version: NA
The 24V Supply quick start procedure on DC2374B is performed.
Starting from Vbat = 10V and then incrementing Vbat to switch to float mode (current charge = 0A) is okay. It works as expected.
In this point I decrease Vbat to get FB < LB condition but the charging is not re-initiated as claimed in the LTC4013 datasheet (page 13)
In order to re-initate the charge I have to switch ON->OFF and then OFF-ON the ENAB pin.
Could anyone clarify this?
gaston
Edit Notes
text correction[edited by: gschelotto at 6:53 AM (GMT -4) on 19 May 2023]
