MAX635 Inductor Value?

Question

I implemented this design to get the value of 5V from the value of -2V. I read and applied the part about inductor calculation in the datasheet document, but I am not sure that I got the value range correctly. Can someone review my schematic and tell me if there is an error with an inductor value or something else?

ADIApproved · Accepted Answer

Hello Ukaracaoglu, 
 Maxim Integrated products are not supported on EngineerZone at this time. Please visit one of the support sites listed below for assistance with Maxim Integrated products. For more information about the Maxim Integrated acquisition please visit: https://www.analog.com/en/about-adi/maxim-integrated-acquisition.html 
 EN - https://maximsupport.microsoftcrmportals.com/en-US/tech-support/ CN - https://maximsupport.microsoftcrmportals.com/zh-CN/tech-support/ JP - https://maximsupport.microsoftcrmportals.com/ja-JP/tech-support/ RU - https://maximsupport.microsoftcrmportals.com/en-US/tech-support/ 
 Regards, 
 Nino)

Electronic Design Services - PartnerZone

Products Mentioned

MAX635 Inductor Value?