LT8301 Typical Application Don't work Vin=24V Vout=24V

Question

I bought a DC2737A because a typical application don't work on my breadboard. 
 So i bought a DC2737A for respect the layout.

For my application i change T1,D2 and C2 to correspond at my out voltage (24Vout). I change the transfo by this ref 750313975 and D2 by BZT52C24T-7 and C2 by a capa 4,7uF 35V. 
 
 This tipycal application don't work the out voltage is not 24V but 2V at 50mA. 
 I don't understand why but i suppose the transformator is not correct to this typical application. Somebody have already test this schematic typical application ?

ADIApproved · Accepted Answer

Hello Yoyo91, 
 I tried simulating the circuit with the recommended transformer 750313975. The simulation showed an output of 24 Volts at 150mA as expected so I think the transformer should work fine for your application. Below is the simulation file. 
 Try changing the Schottky diode, D1(PMEG3020EH) with another that has atleast a reverse voltage greater than 48V. Let me know if the problem persists. 
 LT8301_24Vout.asc 
 Regards, 
 Nino)

Partner Forums

Partner Libraries

Products Mentioned

LT8301 Typical Application Don't work Vin=24V Vout=24V