Category: Software
Product Number: LTM8063
I was planning on using the LTM8063 as an inverting SMPS to go from +12V to -5.5V. Simulation seems to work ok. I have followed the datasheet suggestions and added extra circuitry.
1) Is there anything in my schematic that is wrong, so wrong that it won't work?
2) Regarding the layout, is it just a matter of flipping names of the pads for Vout and GND? I need to make room for the extra devices like more bulk capacitance or diodes but just for the general concept that I did this right.
dennis
