Post Go back to editing

Absolute voltage range of VSW of LTC3411EMS

Category: Software
Product Number: LTC3411

Hi,

I have confirmed negative voltage that exceed the absolute maximum voltage of VFB. It seem like -1V transiently.

I also confirmed LTspice waveform that exceed the absolute voltage range too.


Is it ok, if I exceed the absolute maximum voltage transiently or not.

Best Regards,

  • Hello,

    Sorry for the late response. The -1V spikes that you observe every switching cycle in the SW node is expected especially on buck converters and will not damage the part. These spike drops during switching operation are due to the inductor current flowing through the body diode of the low-side MOSFET during dead time which causes a voltage drop across the body diode hence, the -1V that you observed.

    The stated -0.3V absolute maximum rating is a dc rating. This means that the part will be damaged once an external constant voltage (for example, a dc source or any external source other than the output inductor) that is below -0.3V is applied at Vsw.

    Regards,

    Nino

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.