About single output 20A in LTpowerCAD of LTM4646

Hello

thank you for your reply.
I would like to simulate a circuit that can flow 20A with one output with LTPowerCAD.
If you have a confirmation method or data that can output 20A per output with LTPowerCAD, please share it.

I would be grateful if you could reply.

Best Regards,
Knj

Can you confirm if I'm understanding you correctly. You want to use only one phase, and it should be 20A, is that correct?

Hi Knj,

I believe LTpowerCAD can support that. Please open LTpowerCAD and search for LTM4646. Enter your specifications and make sure the max paralleled option is set to 2.

Thank you for your reply.

The data you received seems to have two devices connected in parallel, but is it a collection of two outputs from one device?

Taking LTM4668A as an example, by setting the output to two, the output of one device is combined.

However, if you do the same with LTM4646, you will get an error.

Please let me know if there is a way to combine the outputs of one device with LTM4646.

I would be grateful if you could reply.

Best Regards,
Knj

I think this is because you did not set the max paralleled output to 2. If you look at the two outputs, Vout1 and Vout2, they are tied together. It also says that this design is a 2-phase design with 10A per phase to produce a total output of 20A.

Thank you for your reply.

#Paralleled Phases corresponds to the #n part of the figure, and I thought that two devices were connected.

If I set #Paralleled Phases to 2, should I recognize that I'm combining 2 outputs from 1 device?

I would be grateful if you could reply.

Best Regards,
Knj