Problem with LTC4236 12V 25A design

Hi N.ATAHAN,

Are you using the demo board? If not, it is always a good idea to get the demo board so you have working reference board. You can also double check and verify your design first using LTspice. 

Thanks for your answer. Working successfully in LTspice tests. But in reality HotSwap mosfet is not switching. I think a simple switching board can be made by reading the datasheet without buying a development board.

The problem was solved by using SUM90N10-8M2P-E3 coded mosfets instead of IRL40SC209 mosfets used in the design. From now on, load tests etc. will continue.
My esteemed designer friends, the Mosfet Selection section in the LTC 4236 datasheet is insufficient. No info on why I shouldn't choose the IRL40SC209 mosfet. For your information...
I wish everyone a day full of research.

 What is the reason why the IRL40SC228 / IRL40SC209 codes mosfet does not turn on? What should I pay attention to when choosing a mosfet? I need to choose a mosfet in the redundant power design of the system that draws 25A continuously. Which mosfet model should I use for the LTC4236?