I have designed a 6S 12V Lead Acid Battery Balancer circuit using 2 x LTC3305, but I don't have 8 x Power supply to do the test. I'm looking for suggestion to test the circuit before I connect the board to the battery cell.
Can I do the following:
1. Connect PS to BAT1. Increase voltage slowly to 12V while monitor the current.
2. Disconnect the PS and connect it to a battery cell. Repeat this for BAT2 to BAT6.
Note: The EN1 and EN2 pins are enable for both LTC3305.
Hi chinkiat,
We think that you really need several supplies to act as batteries to connect to all the BAT locations. Either you get multiple-output battery simulator or build your own. An example is something like below. Several channel isolated flyback converters. You may take a look at LT3837.
Hi chinkiat,
We think that you really need several supplies to act as batteries to connect to all the BAT locations. Either you get multiple-output battery simulator or build your own. An example is something like below. Several channel isolated flyback converters. You may take a look at LT3837.
