LTC4060 charging with 1A

Hello,

I have some trouble with the following. In the datasheet of the LTC4060 I found the following schematics.

For my design I want to charge 2 series NiMH batteries at 1A. In my design I calculated the right Rprog.
What I don't understand from the picture is how figure 2 is able to charge with 2A.
Since the pads of the LTC4060 are 0.25mm wide it should not even be possible to draw 1A.

What should the trace width and the correct schematic be for charging with 1A?

Thank you,

Jorg

Parents Reply Children
No Data