KCC's Quizzes AQQ305 about a mutual exponentiation equation
1. Quote of the month: "A train station is where a train stops. A bus station is where a bus stops. I have a work station on my desk, so..." - unknown
2. Quiz AQQ305 about finding a mutual exponential equation
Good luck, and try to be among the
View All
October Monthly Blog Quiz! Read the blog, take the quiz, and you could win a gift card
Finding Your Circuit Chi — EMC Quiz!
Think you know EMC? Test your knowledge with our 5-question quiz!
Read the blog first, then take the challenge: Finding Your Circuit Chi
Every current flowing creates electromagnetic fields.
Strong EMC design
View All
LT1764A
Recommended for New Designs
The LT1764A is a low dropout regulator optimized for fast transient response. The device is capable of supplying 3A of output current with a dropout voltage...
Datasheet
LT1764A on Analog.com
LTspice
Production
LTspice® is a powerful, fast, and free SPICE simulator software, schematic capture and waveform viewer with enhancements and models for improving the simulation...
LTspice on Analog.com
Hi,
I am working on an application that required paralleling two LT1764A in order to get the current we needed.
We basically implemented the circuit exactly as recommended on the LT1764 datasheet (page 20) : https://www.analog.com/media/en/technical-documentation/data-sheets/1764fb.pdf

The problem we have is the circuit is oscillating badly, investigating I found the article: https://www.analog.com/en/technical-articles/paralleling-linear-regulators-made-easy.html.
I was trying to reach Kevin, kevin.scott@analog.com the author of the article but looks like the listed email is dead.
I wonder if you can give me some advice.
I have the LTSpice simulation file. Note the pcb trace from the Op amp output to the Resistor is a little long, adding 10pF to simulate that makes the circuit oscillate similar to what we are seeing in our application.
The only way I found to stop the oscillation is adding a 0.1uF cap from the Op Amp +in to ground.
Thanks in advance and best regards,
Jorge Gomez.
Hi Jorge,
Can you tell us what is exact input and output specs of your application?
Hi Jorge,
Can you tell us what is exact input and output specs of your application?
Hi Jorge,
Hope you are doing well.
One possible reason for oscillation is that your circuit is having a hard time establishing a proper master-slave configuration. In my LTspice simulation, (the simulation was in reference to that of the schematic you have shown here) adding a 10PF on the output of the op amp didn't result to oscillation. Can you share your simulation here? Also as what Fil said before, can you tell us the exact input and output specifications and if possible, a schematic and layout of your design?
Regards,
Siglo