I'm using LT8491, and my battery doesn't have NTC resistor divider network, only have VDD & GND pin.
Can LT8491 detect battery disconnected without TEMPSENSE pin? How to do that?
LOW_VBAT_FLT can be used to prevent operation when there is an open load. Be sure to set UV thresholds appropriately.
Note: CFG_UV_S0 and CFG_S0_UV allow the charger to start even if there is a battery protection circuit in between
the VBAT terminal and the battery. Setting both registers to 0x00 ensures that the charger can start and will not enter
fault, even if the initial VBAT voltage is 0.