ADP2164 Forced continous switching

I would like to free-run the ADP2164 at ~650Khz but do not want it to go into pulse skip or burst mode with no load.

I can calculate the RT value but the question is with the SYNC pin.

Can I tie the Sync pin low to do this or is there another way to force continuous switching at very light loads?

Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 3:03 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 3:03 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data