Hello
Our customer will use ADM6328 and ask below question.
Question1
VCC to reset delay is 20us (typ) as datasheet Table.1
If VCC is returned over VTH within 20us after VCC went the value under VTH,
does low of reset signal output ?
( Please let me know your advice about logic state of red circle in attached file)
Question 2
Datasheet says hysteresis 6.3mV (typ).
If you have any data about temperature drift or deviation data of hysteresis,
could you please give use it ?
It is concerned how a noise affect ADM6328 operation and he asks above.
Please let me know your advice.
Regards,
Teruamsa
