Post Go back to editing

LTM8002 PCB Layout

Hello all,

Regarding the LTM8002 Recommended PCB Layout, I wanted to know if the following components layout is acceptable (compared to the recommended datasheet layout):


1- Output capacitor ground return path loop is much shorter than the recommended layout

2- Signal ground is more isolated from power ground (connected only to A7 pin)


1- Feedback resistor is placed at bottom layer, and the resistor connection to ground is a bit longer - can it cause problem? 

Can someone say why I shouldn't  use this layout?



[edited by: Nir76 at 1:00 PM (GMT -4) on 28 Sep 2020]